Optical Mode; Coaxial Mode - Edifier R2850Db Manuel D'utilisateur

Line In 1/Line In 2 mode
• Press the "LINE1" or "LINE2" button on the remote control, or press the "volume/input" dial on the active speaker to select
Line In 1 or Line In 2 input mode; green LED will flash once in Line In 1 mode, and will flash twice in Line In 2 mode;
• Connect audio source (mobile phone, tablet, etc.) to the "Line In 1" or "Line In 2" input port (note color matching) on the rear
panel of the active speaker using audio cable;
• Play music on the connected device and adjust the settings to a desired level.

Optical mode

• Press the "OPT" button on the remote control, or press the "volume/input" dial on the active speaker to select optical mode,
red LED will flash once;
• Connect audio source (Set Top Box, Blu-ray player, etc.) to the "OPT" input port on the rear panel of the active speaker using
fiber optic audio cable;
• Play music on the connected device and adjust the settings to a desired level.

Coaxial mode

• Press the "COAX" button on the remote control, or press the "volume/input" dial on the active speaker to select coaxial mode,
red LED will flash twice;
• Connect audio source to the "COAX" input port on the rear panel of the active speaker using coaxial cable (coaxial cable not
included);
• Play music on the connected device and adjust the settings to a desired level.
Note:
Only the standard PCM audio signals (44.1KHz/48KHz/96KHz) function in optical/coaxial mode.