Rear Panel; Remote Control - Marq Haze 800 DMX Guide D'utilisation

Features

Rear Panel

1. Cap: Twist this cap clockwise to tighten it or counterclockwise to
loosen it. The tube that passes through its center feeds the fluid in
the tank to the heater.
2. Tank: Fill this tank with a high-quality, water-based haze fluid only.
Using non-water-based fluids with this product will void its
warranty.
3. Power Cord: Connect this attached power cord to a power outlet.
4. Fuse: If the fuse is broken, disconnect the power cord from the
power outlet, and then unscrew this holder to replace the fuse.
Replace it with a fuse with an appropriate rating (printed under on
the rear panel). Using a fuse with an incorrect rating can damage
the product and/or fuse.
5. Power Switch: Use this switch to power Haze 800 DMX on or off.
After powering it on, wait for 2–3 minutes until the heater is warmed
up and the Ready light on the remote control illuminates.
6. Remote Control Input: Connect the remote control to this input.
7. DMX In: Use a standard 3-pin DMX cable to connect this input (A)
to your DMX controller or (B) to another device that will pass DMX
data through it to this one. Haze 800 DMX receives DMX data over
this connection. Please see
information about linking multiple devices.
8. DMX Out: Use a standard 3-pin DMX cable to connect this output to an additional device. Haze 800
DMX sends its data to an additional device over this connection. Please see
Linking for information about linking multiple devices.
9. Display: This display shows messages and values indicating the current status.
10. Function: Press this button to access Haze 800 DMX's menu.
11. Up/Down: Press these buttons to the move next-highest/next-lowest menu option or to
increase/decrease the value by 1.

Remote Control

1. Power Light: This light will illuminate when Haze 800 DMX is powered on.
After powering it on, wait for 2–3 minutes until the heater is warmed up and
the Ready light on the remote control illuminates.
2. Ready Light: This light will illuminate when Haze 800 DMX is warmed up and
ready to use.
3. Timer Light: This light will illuminate when the timer is activated.
4. Timer On/Off: Press this button to activate or deactivate the timer. See
Operation > Usage
5. Continuous: Press this button to activate or deactivate a continuous output of
haze.
6. Manual: Press and hold this button to activate a continuous output of haze.
Release the button to deactivate it.
7. Output: Turn this knob to control the amount of haze (0–100%).
8. Interval: Turn this knob to set the amount of time between each release of
haze (approximately 1–30 min.).
9. Duration: Turn this knob to set the length of time of each release of haze (approximately 1–30 sec.).
Operation > Setup > DMX Linking
to learn more.
9
10 11
6
7
8
5
3 4
for
Operation > Setup > DMX
8
3
4 5 6
1
2
9
7
1 2
3