Door - Rca Rfr459-B-Com Mode D'emploi

CHANGING
CAUTION: To avoid personal injury to yourself and/or property, we recommend someone
assist you during the door reversal process.
Your refrigerator is built with a reversible door. You have the choice of either opening it from the left
or the right side. In order to reserve the opening direction of your door, please follow these simple
instructions:
1) Disassemble all the reversible components
diagram above). Be sure to keep them well for later use in the process of reassembling.
leveling leg II
(2) bottom hinge
(3) leveling leg I
(4) bottom door baffle block
(5) 2 screws to hold bottom hinge
(6) door, refrigerator section
(7) mid hinge
(8) 2 screws to hold mid hinge
2) TO access the bottom hinge assembly,
refrigerator on its back.
3) Remove the upper door right stopper (9), install the upper door left stopper (15) on the opposite
side; take down the bottom door baffle block (4), and install it on the opposite side
4) Reassemble the unit with the door hinges on the opposite side (see the right diagram above).
The sequence for reassembling is just in reverse order of disassembling
5)
With the mid hinge not being fastened too tight, align two doors properly on the cabinet and then
fasten the mid hinge. If necessary,
then fasten them tight
THE REVERSIBLE
\ (12)
00000000
(11)
00000000
00000000
00000000
00000000
(9
7)
(6
5)
in the sequence as shown below (also refer to left
you may tilt back the refrigerator
loosen the bottom hinge and the top hinge when aligning and
8

DOOR

00000000
00000000
00000000
00000000
10)
00000000
6)
(9) upper door right stopper
(10) door, freezer section
(11) top hinge
(12) 2 screws to hold top hinge
(13)
Door hinge cover
(14)
Plug
(15) upper door left stopper
cabinet or lay the