Koba Vision ZoomCam Mode D'emploi page 6

Use the USB-C (PC) connection to connect the ZoomCam on a computer, tablet or smartphone. If the
device does not have enough power, use the second USB (PWR) connection. Use:
•
USB-C cable → connect it to the outer USB-C connector (PC) - 3
•
If the ZoomCam does not have enough power or if you want to connect an external battery, use a second
USB cable → connect it to the middle USB-C connection (PWR) - 2
USB 3, type USB-C
The ZoomCam works optimally with a USB 3, type USB-C.
USB 3, type USB-A
It is also possible to use a USB 3, type USB-A. This port may not provide enough power. If the ZoomCam
is not receiving enough power, the LED flashes 6 times red at the next start-up. In this case, connect the
ZoomCam with a USB-C cable, connect the power supply or connect a second USB cable to the computer
or tablet.
USB 2, type USB-A
It is also possible to use a USB 2, type USB-A. This port does not provide enough power. If the ZoomCam
is not receiving enough power, the LED flashes 6 times red at the next start-up. In this case, connect the
power supply or connect a second USB cable to the computer or tablet.
Chapter 3: Operation
REMOTE CONTROL
The ZoomCam is operated with a remote control. The remote control has 2 AAA batteries. On the back of
the remote control there is a cover that you can slide down to replace the batteries.
The receiver is located between the lights in the horizontal arm of the ZoomCam.
The LEDs on the front and back of the ZoomCam flashes when a button is pressed on the remote control.
KOBA Vision ZoomCam 6