LOOOX EASY Instructions D'utilisation page 3

Use / instructions
EN
PLEASE NOTE! Read these instructions prior to assembly and use! Check for damage before assembly. Any damage reported
after assembly or damage caused by failure to observe these instructions is not covered by the guarantee.
Congratulations on the purchase of your bath! To keep the bathtub in optimal condition, various recommendations for use and
maintenance apply. Please read these carefully. Any excess sealant can be removed with a sponge and plenty of water.
Recommended use and maintenance
Cleaning the bath is very easy, because dirt has almost no chance to attach itself to the surface. The best way to maintain this effect
is to dry the bath with a soft cloth after use. When it comes to maintenance, we make a distinction between two different finishes:
mineral marble with a gelcoat top layer and acrylic.
Mineral marble with a gelcoat top layer (Easy)
To clean the bath, use mild soap and a soft sponge. Rub gently in a circular motion and use plenty of water. For stubborn
stains that cannot be removed in the manner described above or if there is damage, please contact our service department.
For stubborn stains that cannot be removed in the manner described above or if there is damage, please contact our service
department.
PLEASE NOTE!
Do not use solvents such as:
- alcohol (or alcohol-containing)
- acetone (or based on acetone)
- ammonia (or based on ammonia)
The area where the logo is located must be treated with extra care. In addition, we do not recommend the use of bathbombs, bath
pearls and oils. This is to prevent color stains.
Acrylic (Cool, Cool Wall, Chill and Chill Wall)
To clean the bath, use a liquid cleaning agent, water and a soft sponge. Rub gently in a circular motion and use plenty of water.
Always rinse immediately and thoroughly with water. For stubborn stains that cannot be removed in the manner described above
or if there is damage, please contact our service department.
PLEASE NOTE!
Do not use solvents such as:
- alcohol (or alcohol-containing)
- acetone (or based on acetone)
- ammonia (or based on ammonia)
The area where the logo is located must be treated with extra care. In addition, we do not recommend the use of bathbombs, bath
pearls and oils. This is to prevent color stains.
Before installation:
During installation of the piece you have acquired, handle it on a clean, dry surface to prevent scratching. Residues of
setting materials should not be allowed to harden on the surface of the piece. To clean off residues of setting materials
before they harden, remove them with a damp cloth, always avoiding scouring pads that could scratch the surface.
PLEASE NOTE!
Do not use abrasive or aggressive cleaning agents such as:
- chlorine
- hydrochloric acid
- caustic soda
- limescale removers
- solvents based on anionic surfactants
PLEASE NOTE!
Do not use abrasive or aggressive cleaning agents such as:
- chlorine
- hydrochloric acid
- caustic soda
- limescale removers
- solvents based on anionic surfactants
3