Transportation And Storage; Residual Risk - Ryobi OES1813 Traduction Des Instructions Originales

QUICK GUIDE TO EASYSTART ELECTRICAL WRENCH
WARNING
Before each use, ensure the EasyStart electrical wrench
will not operate by pressing the switch button when the
wrench is not attached to the petrol engine. If the wrench
turns, do not use the wrench. Bring the product to an
authorised service centre for repair.
WARNING
Before each use, ensure that the starter bit rotates in one
direction only. If the starter bit rotates in both directions,
do not use the wrench. Obtain a replacement starter bit
from an authorised retailer or service centre.
■ If the EasyStart electrical wrench does not engage
properly into the EasyStart port on the petrol engine,
rotate the exposed bit by hand until the wrench is
properly engaged.
NOTE: The starter bit will only rotate in one direction
due to the one-way bearing inside it.
■ Prepare and check if your garden tool is in safe
condition to start. Read its instruction manual.
■ Check for the triangle or pentagon symbol beside the
EasyStart port on your garden tool engine. Insert the
starter bit into your EasyStart electrical wrench with the
corresponding starter bit shape facing out.
■ Insert the battery pack into the EasyStart electrical
wrench.
■ Set the throttle and choke as specified in the instruction
manual for your garden tool.
■ Insert the EasyStart electrical wrench into the port on
the engine. Make sure the wrench is properly seated,
otherwise the safety interlock will not allow the wrench
to work and you may damage the wrench or the engine.
■ Press the start button on the wrench and allow it to
turn over the engine for less than 4 seconds or until the
engine starts. Wait for few seconds before turning over
the engine again.
■ Release the start button, remove the wrench, and place
it down in a safe position.
■ Adjust the choke and throttle of the garden tool engine
as directed in its instruction manual for efficient running
and operation.
■ Use the garden tool to complete the task.

TRANSPORTATION AND STORAGE

■ Stop the product, remove the battery, and allow both to
cool before storing or transporting
■ Clean all foreign material from the product. Store it in a
cool, dry, and well-ventilated place that is inaccessible
to children. For extra safety, store the battery separately
from the electrical starter. Keep away from corrosive
agents such as garden chemicals and de-icing salts.
Do not store outdoors.
TRANSPORTING LITHIUM BATTERIES
Transport the battery in accordance with local and national
provisions and regulations.
Follow all special requirements on packaging and labelling
when transporting batteries by a third party. Ensure that
no batteries can come in contact with other batteries
or conductive materials while in transport by protecting
exposed connectors with insulating, non-conductive caps
or tape. Do not transport batteries that are cracked or
leaking. Check with the forwarding company for further
advice.
MAINTENANCE
WARNING
Use only original manufacturer's replacement parts,
accessories and attachments. Failure to do so can
cause possible injury, poor performance and may void
your warranty.
WARNING
Servicing requires extreme care and knowledge
and should be performed only by a qualified service
technician. For service we suggest you return the
product to your nearest authorised service centre for
repair. When servicing, use only identical replacement
parts.
■ Remove the battery before adjusting, maintaining, or
cleaning the product.
■ You may make adjustments and repairs described in
this manual. For other repairs, contact the authorised
service agent.
■ After each use, clean the body and handles of the
product with a soft, dry cloth.
WARNING
Do not, at any time, let brake fluids, gasoline, petroleum-
based products, penetrating lubricant, etc., come in
contact with plastic parts. Chemicals can damage,
weaken, or destroy plastic which may result in serious
personal injury.
WARNING
If the starter bit is damaged or the one way bearing built
into it does not function, the whole starter bit should be
replaced before use. The use of a damaged starter bit
may result in personal injury or damage to the product.

RESIDUAL RISK

Even when the product is used as prescribed, it is still
impossible to completely eliminate certain residual risk
factors. The following hazards may arise in use and the
operator should pay special attention to avoid the following:
■ Hazards associated with the starting of the outdoor
EN
FR
DE
ES
IT
NL
PT
DA
SV
FI
NO
RU
PL
CS
HU
RO
LV
LT
ET
HR
SL
SK
BG
UK
English | 3