Troubleshooting; Warranty; Register Your Product - Haussmann Xpert PNT162 Manuel De L'utilisateur

!
!
When inserting new or re-installing O-rings, make sure they are clean and lubricated with an O-ring lubricant.
PROBLEM
Air leak in cylinder cap
Tool lacks power or is slow to cycle.
Poor driving and re-setting power
Tool skips fasteners or fasteners feed
intermittently
Fastener is jammed in tool

TROUBLESHOOTING

WARNING: Stop using the tool immediately if any of the following problems
occur. Serious personal injury may result. Any repairs or replacements must be
CAUTION: Disconnect the tool from air supply before performing any service
procedure.
CAUSE
Loose nose screws
Gasket cracked or worn
Tool is dry and lacks lubrication
Air pressure is too low
Exhaust is blocked
Damaged pusher spring
Fasteners are wrong size
Magazine or wear plate is dirty
Driver channel is worn
Driver blade is broken or worn
Bent fasteners

WARRANTY

Thank you for investing in a HAUSSMANN XPERT tool. These products have been
made to demanding, high-quality standards and are guaranteed for domestic use
against manufacturing faults for a period of 36 months from the date of purchase.
This guarantee does not affect your statutory rights. In case of any malfunction of your
tool (failure, missing part, etc.), please contact one of our service technicians at our toll
free service line at 1-866-206-0888 from 8 AM to 6 PM, Monday to Friday, Eastern
time. RONA reserves the right to repair or replace the defective tool, at its discretion.
The product is guaranteed for 36 months if used for normal trade purposes. Any
guarantee is invalid if the product has been overloaded or subject to neglect, improper
use or an attempted repair other than by an authorized agent. Heavy-duty, daily
professional or hire usage are not guaranteed. Due to continuous product
improvement, we reserve the right to change the product specification without prior
notice.

REGISTER YOUR PRODUCT

We invite you to register your product online to make future communications easier.
To do so, simply visit our website www.haussmanntools.com.
CORRECTION
Tighten, then re-check
Replace gasket
Use air tool oil
Check air supply equipment
Clean exhaust channel
Replace spring
Use correct fasteners
Clean magazine and nose
Replace wear plate
Replace driver blade
Use correct fasteners
.
25