Switching The Sound Set - Edirol Studio Canvas Sd-90 Manuel De L'installateur

I Switching the sound set
GM2 mode and Native mode each have four sound sets (variations). You can use MIDI messages to
switch between these sound sets.
Switching the sound set in GM mode
In GM2 mode, you can switch the sound set by transmitting a system exclusive message.
<Example> Switch the sound set of Part 1 to the Enhanced set
Transmit the following system exclusive data:
fig.5-00_99
Part (pp):
Sound set(nn): 00H = Classical set
Checksum(ss): For details on the calculation method,
(pp) specifies the part you want to switch, and (nn) selects the sound set.
Switching the sound set in Native mode
In Native mode, you can switch the sound set by transmitting a Bank Select message. The upper byte
(MSB) of the MIDI bank number will switch the sound set.
MIDI bank number:
After transmitting CC#00, transmit CC#32 (Variation) and PC# (Program Change) messages to switch the
sound ("Switching the sound set in Native mode" (p. 81)).
20H = Part 1
:
3FH = Part 32
01H = Contemporary set
02H = Solo set
03H = Enhanced set
refer to "Calculating the checksum" in
"MIDI implementation"
(MIDIImple_E.pdf) on the included
CD-ROM.
CC#00(MSB)= **
**: The set will be switched according to the value you insert here (decimal)
80(50H) = Special 1 set
81(51H) = Special 2 set
96(60H)= Classical set
97(61H)= Contemporary set
98(62H) = Solo set
99(63H) = Enhanced set
Controlling the SD-90 via MIDI
MIDI Multitimbre Part
F0 41 10 00 48 12 [10 00 pp 3F] [nn] [ss] F7
(1) (2) (3) (4) (5)
(1) Exclusive status
(2) ID (Roland : 41H)
(3) Device ID
(4) Model ID (SD-90 : 00H 48H)
(5) Command ID (Data set : 12H)
(6) Address
(7) Data
(8) Checksum
(9) End of Exclusive
GM2 Instulment
Set Select
03
Part (Enhanced)
(6) (7) (8) (9)
81