Extreme Max 3006.8456 Instructions D'installation

-naäuC7$
Includes:
• Cradle x 2
• Leg Assembly x 4
• Bolt x 8
• Washer x 8
• Nut x 8
Required Tools - Not Included
• 4 mm Hex Key
• 10 mm Wrench or Socket
Read, Follow, and Save
Caution:
• Read and understand all warnings
• Maximum Weight Capacity:
Product Satisfaction
At Extreme Max, we pride ourselves
not 100% satisfied with the product,
Warranty
This product is warranted for consumer
Warranty valid only in the USA.
This product is warranted to the original
wear and tear expected. This warranty
of goods or any acts of vandalism
commercial use. The sole remedy
or similar product, or the refund of the original
or incidental damages. Any and all freight charges to handle warranty
Extreme MaxTM is not responsible
For all inquries please send your name, mailing
summary of alleged defect and any applicable
Installation Instructions
Read all information included
I. Remove the components
2. Locate a cradle and leg assembly.
3. Insert both tapered ends of a leg assembly
Note: If a leg assembly does not align with
have to be adjusted. In this case, fold the leg assembly so the legs run parallel to each other. Keeping the legs
parallel, flip the rope over the capped end of one of the legs. Next, rotate the legs to the open position.
should now properly fit into the frame.
4. Align the holes in the leg assembly with the holes in the cradle and secure in place with a bolt, washer, and nut. Tighten
until snug.
5. Place a second leg assembly into the opposite end of the cradle so that the limiter rope is on the outside of the stand.
6. Align the holes in the leg assembly with the holes in the cradle and secure in place with a bolt, washer, and nut. Tighten
until snug.
7. Repeat steps 2 through 6 for the second stand.
Customer Service: service@extrememax.com
Folding
Installation/Operating
These Instructions.
and instructions before assembly.
165 lbs. evenly distributed
Guarantee
on making quality
for any reason, please
use for 2 years after the date of retail purchase. Warranty
retail purchaser to be free from defects in material
shall not apply to any defects caused by: (I) overloading,
by any person, (III) improper
under this warranty
purchase price. Extreme MaxTM is not responsible
for any labor charges that may be incurred.
address, main contact phone number,
pictures to service@extrememax.com.
above before beginning
from the packaging.
into the cradle so that the limiter rope is on the outside of the stand.
the frame
Kayak Stand - Pair
between two stands.
products and wish to correct any mistakes on our end. If you are
reach out to us. We are here to help!
installation or use contrary to the instructions,
is at the discretion of manufacturer:
claims are the responsibility
operation or installation.
with the rope on the outside
I www.extrememax.com
Instructions
3006.8456
includes parts only.
and workmanship,
(II) physical abuse
the replacement of the same
for any consequential
of the consumer.
original retail sales receipt,
as instructed, the leg assembly
Your legs
ordinary
(IV)
will
3399ex0120