Brizo 61201 Manuel D'installation
Manuels Connexes pour Brizo 61201
Sommaire des Matières pour Brizo 61201
-
Page 2: Cleaning And Care
Replacement parts may be obtained by calling 1-877-345-BRIZO (2749) (in the U.S. and of this warranty applying except the duration of the warranty. This warranty is applicable to... - Page 3 RP31672▲ Spout with Aerator Salida con Aireador Bec avec Aérateur RP31674▲ Spout Bonnet Bonete de Salida Embase de Bec RP21463 Spout Retainer Retenedor de Salida Fixation du Bec RP22934 O Rings Anillos "O" Joints Toriques RP39736▲ Body & Base Cuerpo y Base Corps et Base RP20368 Gasket/Empaque/Joint...
- Page 4 RP21905▲ Head Assembly Ensamble de Cabeza Tête...
- Page 5 SHUT OFF WATER SUPPLIES. INSTALL SPOUT A OR B. 61200 Series: Remove nut, washer and paper tube from spout assembly. Set spout on sink making sure that the base (1) and the gasket (2) are properly aligned on the base of the spout assembly. Mount spout on sink with washer and nut (1) and wrench (2).
- Page 6 Install Valve Assembly Install Sprayer Assembly Remove nut, cardboard tube and washer from the valve assembly. Insert Place gasket and base (1) on mounting surface over far right spout hose up through hole in sink. Making sure that the base and gasket hole in sink.
- Page 7 1/2" (12.70mm) IPS 1/2 po (12.70mm) IPS For models with soap dispenser. Remove nut (1). Insert body assembly (2) MAKE CONNECTIONS TO WATER LINES: through selected hole in sink. Secure body assembly to sink with nut (1). From NOTE: Be careful when bending the copper tubing. under the sink screw the bottle (3) onto the body assembly shank.
- Page 8 Important: This flushes away any debris that could Remove aerator (1) and turn faucet handle (2) to the cause damage to internal parts. full on mixed position. Turn on hot and cold water supplies (3) and flush water lines for one minute. Check all connections at arrows for leaks.