evenes EPO 2-3 Manuel De Montage Et D'utilisation page 11

3. | ASSEMBLY
INSTALLATION WITH THE OUTLET AND
INLET PIPES ON THE BOTTOM.
1.
Install the water system pipes and electric supply cables in
accordance with the relevant regulations
2.
Take off the unit's cover: undo the screws, slide the cover off
starting from the inlet and outlet side
3. Fix the unit in vertical position with the inlet and outlet on the
top, or on the bottom, as in the picture
4.
Connect (e.g. using flexible hoses) cold water to the inlet pipe
inserting a filter in between and connect hot water to the
outlet pipe
5. Open the cold water valve and check for leaks
flow restriction insert
EPO 2-3,5
EPO 2-4,4
EPO 2-5,5
INSTALLATION WITH THE OUTLET AND
INLET PIPES ON THE TOP.
6.
Vent the installation according to the „Venting" section
7.
Connect the unit to electric installation in accordance with
markings, tighten cable clamp to secure cable from slipping
8.
Put the unit's cover back
9.
Make sure that there is no access to live parts through the
holes at the back plate
black 1,9 l/min.
green 2,5 l/min.
violet 3,4 l/min.
ELECTRIC INSTANTANEOUS WATER HEATER EPO 11