Napoleon BLK-OLKTLV74 Mode D'emploi

WARNING
• Failure to position the logs in accordance
with these diagrams or failure to use only logs
specifically approved with this appliance may
result in property damage or personal injury.
• The logs are fragile and should be handled with care.
PHAZER™ logs and glowing embers,
exclusive to Napoleon, provide a unique and
realistic glowing effect that is different in every
installation. Take the time to carefully position
the glowing embers for a maximum glowing
effect. Log colours may vary. During the initial
use of the appliance, the colours will become
more uniform as colour pigments burn in during
the heat-activated curing process.
1
Ensure to separate the
2 locating brackets.
2
Once apart, using a pair of pliers
bend the 10 locating tabs to 90°.
Wolf Steel Ltd., 24 Napoleon Rd., Barrie, ON L4M 0G8 Canada · 1(866)820-8686 · www.napoleon.com
BLK-OLKTLV74 Birch Log Placement
For Model TLV74/LV74/LVX74
Burner Overview
LEFT BRACKET
• Logs must be placed in their exact location in the
appliance. Do not modify the proper log positions,
since appliance may not function properly and
delayed ignition may occur.
note:
• Log numbers are located on the bottom or back of logs.
• If installing logs into LV/LVX, or Galaxy units the brackets
aren't required. The logs can be placed as shown making
sure not to cover the burner or pilot housing. When crossing
the burner make sure to cross a valley (low spot in the flame
pattern). Flame impingement may cause carbon log and
you may need to move the log away from the flame.
RIGHT BRACKET
W415-4158 | C-0 | 03.03.25