Mounting And Cleaning Pad; Neutralizing - Walter Surface Technologies MINI SURFOX Manuel De L'utilisateur

6
Start-up procedure
B) Mounting and cleaning pad
Squeeze and insert clamp ring
Insert cleaning pad
Press in wand tip
Remove tip with installed pad
10
7

Neutralizing

Neutralizing
The SURFOX-N liquid is a specially formulated cleaner
and neutralizer for the SURFOX electrolyte solutions. It is a
powerful ready-to-use formula which leaves no residue, is
non-toxic, solvent free, water-based and biodegradable.
Directions for cleaning and neutralizing
SURFOX electrolyte cleaning solutions:
1. Remove any excess SURFOX-T electrolyte solution
using a soft clean cloth. (This step is not required with
SURFOX-G)
2. Spray SURFOX-N on the surface.
3. Wipe dry with a SURFOX POWERCLOTH.
For more information about this product, refer to product
MSDS.
WARNING! When using SURFOX-T, be sure to wipe off all
excess from the surface and clean/neutralize to prevent salt
residues.
Clean the weld using the SURFOX machine and SURFOX
electrolyte solutions. Work only 2 feet at a time.
Note: the cleaning pad/brush should be kept moist –
not dripping .
1. After weld cleaning, use a clean cloth or paper towel
and wipe the affected area in a squeegee action from left
to right. Then discard the cloth or paper towel. (This step
is not required when using SURFOX-G)
After cleaning the weld with the SURFOX weld cleaning
machine, the electrolyte solution must be cleaned and
neutralized.
1. Spray the affected area with SURFOX-N cleaner and
neutralizer. Allow to sit for 15 seconds on the surface.
2. Use a SURFOX POWERCLOTH and wipe the affected
area in a squeegee action from left to right.
Note: failure to neutralize or neutralize properly the
SURFOX-T electrolyte solution will result in clouding, hazing
and dulling of the surface.
SURFOX-T electrolyte
deposit due to unproper
neutralization and rinsing.