Cleaning The Accessories - Forza PLUS F5 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Before attempting to carry out any maintenance, disconnect the steam/vacuum cleaner from the
mains by unplugging the appliance. The appliance will only be disconnected from the mains once
it is disconnected from the power outlet. When maintenance is complete and before reconnecting
the steam/vacuum cleaner to the mains, make sure that all parts have been reassembled properly.
Cleaning the recovery tank and accessories.
Check the state of picked up matter on a regular basis. Empty and clean the recovery tank and
the accessories after each use.
For better accessory efficiency, clean the O-rings on a regular basis.
Before attempting to clean the tank, you must
deactivate the main switch, unplug the appliance,
and wait for the machine to cool down.
Do not immerse the appliance in water! It is absolutely
forbidden to service the inside parts of the machine.
The recovery tank (2) should be cleaned on a regular basis
to remove any fluid or contamination. Release the latches
(6) and lift the top part of the appliance (1).
For cleaning, follow the instructions below:
- Empty the recovery tank (2).
- Fill a container with up to 3 litres of clean water.
Disinfectants may be added as long as they are foam-free.
- Activate the vacuum function using the vacuum button (19)
and draw water through the accessories previously used for
cleaning.
- Empty the recovery tank (2) and repeat the operation as
necessary.
Every time the bottom part of the appliance is cleaned, clean
any solid residues off the outside of filter (A) (Fig. 24).

CLEANING THE ACCESSORIES

Clean the accessories (extension hoses, multi-purpose brush,
nozzle, textiles tool) with running water. It is advisable to use
steam when cleaning the frames.
Fig. 24
38
A

Publicité

Table des Matières
loading

Table des Matières