PCE Instruments PCE-GA 5 Mode D'emploi page 4

APP
Scan the QR code or find "Smart Life" from GooglePlay/APP Store to get the free application for Android
or iOS. Upon installation of APP on your phone, the app will guide you through registering, connecting the
detector to the internet.
Add your detector
Smartlink(EZ) mode
»
Tap Add Device or "+", select Security & Sensors from Add Manually, then tap Gas Detector(Wi-Fi).
Choose your local Wi-Fi and input password(Only 2.4GHz Wi-Fi network is supported).
»
Power your detector off. Press and hold the button, then power your detector on, don't release until the
screen says "Smart Mode, Connecting".
»
Tap Fast flashing, wait the configuration finishes.Tap the pencil to name your detector, then tap Done.
Soft AP Mode
Please change to Soft AP Mode if the configuration fails in Smarlink Mode.
»
Power your detector off. Press and hold the button, then power your detector on, don't release until
the screen says "Smart Mode, Connecting".Click the button again and the screen says "AP Mode,
Connecting"
»
Tap the top right icon in APP to select "AP Mode", then tap "Slow flashing".
»
Tap Confirm > Go to Connect, then choose the Wi-Fi hotspot named "Smartlife-XXXX" in your Wi-Fi list.
Go back to your app to wait the Wi-Fi configuration finishes
4