Fiap profinet FishTrap 1-fold Mode D'emploi page 5

GB FISH TRAPS & BASKETS
STEP 2
Insert the two shorter weight rods into the designated holders on the Type 2 body and
the longer ones into Type 1. Secure the rods to the clip side with cable ties.
STEP 3
Place the Type 2 body with the smaller diameter on the ground. Place a board under the
body to prevent the hooks from touching the ground and cancel.
Before installing the Type 2 throat, you have the option of expanding the opening by cut-
ting it off, for example to catch smelt or larger eels.
STEP 4
Place the Type 2 throat on the Type 2 body so that the hooks reach through the corre-
sponding recesses. Lock the throat by turning it to the right.
STEP 5
The inlet type 2 is then placed on the hooks and locked by turning it to the right.
STEP 6
Secure the connection with 4 cable ties.
STEP 7
Now place the fish trap on the ground with the inlet facing down and place the end piece
on the hooks. The connection is made by turning to the right.
STEP 8
Secure the connection with 4 cable ties.
STEP 9
Insert the cap with the bait basket and screw it on.
STEP 10
To attach the anchor rope, you can pull a 6-8 mm thick line through the hole and knot it.
The cap handle should NOT be used for this.
5