General Safety Precautions; Technical Details; Kit Components - Häfele Olly E Manuel D'installation Et D'entretien

GENERAL SAFETY PRECAUTIONS

This installation manual is intended for professionally competent personnel only.
Installation, electrical connections and adjustments must be performed in accordance with Good Working Methods
and in compliance with applicable regulations.
Before installing the product, carefully read the instructions. Bad installation could be hazardous.
The packaging materials (plastic, polystyrene, etc.) should not be discarded in the environment or left within reach
of children, as these are a potential source of hazard.
Before installing the product, make sure it is in perfect condition.
Do not install the product in an explosive environment and atmosphere: gas or inflammable fumes are a serious
hazard risk.
Before installing the motors, make all structural changes relating to safety clearances and protection or segregation
of all areas where there is risk of being crushed, cut or dragged, and danger areas in general.
Make sure the existing structure is up to standard in terms of strength and stability.
The motor manufacturer is not responsible for failure to use Good Working Methods in building the frames to be
motorised or for any deformation occurring during use.
Before making power connections, make sure the plate details correspond to those of the power mains.
Fit an omnipolar disconnection switch with a contact opening gap of at least 3 mm. Make sure an adequate
residual current circuit breaker and overcurrent cutout are fitted upstream of the electrical system.
When necessary, connect the motorised door or gate to a reliable earth system made in accordance with
applicable safety regulations.
During installation, maintenance and repair, interrupt the power supply before opening the lid to access the electrical
parts.
To handle electronic parts, wear earthed antistatic conductive bracelets.
The motor manufacturer declines all responsibility in the event of component parts being fitted that are not
compatible with the safe an correct operation.
For repairs or replacements of products only original spare parts must be used.
OUTSIDE
Fig. 3
12 48
OLLY E
10 60
INSIDE
Fig. 2
Fig. 4

1. TECHNICAL DETAILS

Power supply
Current
Motor power
Thrust
Speed
Max. stroke
Max. load
Temperature
Degree of protection
Control panel
Degree of protection C.P.
Service class

2. KIT COMPONENTS

Push-button station with built-in 161 control panel
1JE Actuator
Belt fastening braket
Driving belt
External connector box
Flush mounted connector box
Galvanized self.tapping screw nat. TPS SP
6
230 V~ / 50 Hz
0.2 A
24 V= / 1.8 A
50 N
0.1 m/s
3500 mm
80 kg
-15° C / +50° C
IP20
161
IP40
2 - LIGHT
(minimum 10 cycles a day
for 10 years or 20 cycles a
day for 5 years)
1
1
2
1,5 m
1
1
2