Hardware Installation; Software Installation; Safety Instructions - i-tec U3EXTEND Mode D'emploi

EN
INTRODUCTION
Simple USB 3.0 Extender allows you to get internal USB 3.0 port into 3,5" front
panel position and extend it into 2 x external USB 3.0 port. Device allows you to
use USB 3.0 ports placed on frontal part of your PC. You will not have to find USB
3.0 ports at the back of your PC anymore.

HARDWARE INSTALLATION

1) Connect USB 3.0 connector of the device to USB 3.0 internal port on
motherboard in your PC.
2) 45 cm USB 3.0 cable is enough long to get the panel on front of your PC in
anyone PC Case.
3) Finally fix the metal construction into front 3,5" position of your PC helping
attached screws.

SOFTWARE INSTALLATION

Windows 7/8/8.1/10, macOS X and higher
You must to have installed the latest driver for your USB 3.0 controller on
motherboard of your PC.
PACKAGE CONTENTS
• i-tec USB 3.0 2 Port Internal Front Panel Extender with 45 cm Cable
• 6 screws for fixing the metal construction
• User Guide

SAFETY INSTRUCTIONS

• Do not expose to extreme temperatures and air humidity.
• Use the device on flat surfaces – you will prevent it from slipping and falling
to the ground.
• Save the user manual for a possible use later.
In cooperation with the service department:
• Check functionality after falling to water or to the ground.
• Check functionality when the cover is broken.
• Send the device back if it does not work in accordance with the user
manual.
FREQUENTLY ASKED QUESTIONS
Available on our website www.i-tec.cz/en on the "FAQ" tab of this product.
6
Quick Start / Internal Front Panel Extender