Fortin GM5 Guide D'installation

KEYPAD GM5
Copyright © 2008, FORTIN AUTO RADIO INC
CRUISE KEYPAD FOR CHEVROLET AND PONTIAC
VEHICLE FIT GUIDE
VEHICLES YEARS
07 08 09
CHEVROLET
Equinox
07 08 09
PONTIAC
Torrent
FIGURE
FIG.1
INSTALLATION
1)
Make the connections.
2)
Choose location as flat as possible (slight curve is alright).
3)
Disconnect the keypad switch connector from PCB and drill a hole (if needed)
large enough to pass the wires through.
4)
Make sure the surface is clean before mounting the keypad.
5)
Pass the keypad flexible cable with connector through the hole, remove the
backing and stick it to the dash.
6)
Reconnect the keypad connector with the PCB as the TOP label show.
7)
Test drive the vehicle and test all the buttons on the keypad.
TECHNICAL SUPPORT / INFORMATION
Neither the manufacturer or distributor of this module is responsible
of damages of any kind indirectly or directly caused by this module,
except for the replacement of this module in case of manufacturing
defects. This module must be installed by qualified technician. This
instruction guide may change without notice. isit www.ifar.ca to get
latest version.
PATENTE PENDING
ALL RIGHTS RESERVED
Flexible
cable
DATA WIRE RED
Purple
Purple
V
Black connector
at the top of the
steering column
Red Purple
Blue Grey
Black To Ground
DATA WIRE BLUE GROUND BLACK
Grey
To ground
Grey
To ground
PROGRAMMING PROCEDURE
1) Connect the GM Tech II into the OBDII connector
2) Load the informations of the vehicle
3) Connect on GM online
4) Select the option: CRUISE KEYPAD
of the vehicle,
5) Connect back the GM Tech II
6) Update the vehicle PCM.
Technical support:
TEL: 514-255-HELP (4357)
FAX: 514-255-1367
Web: www.ifar.ca
INSTALLATION GUIDE
Made in Canada -Rev.C - 28 / 08 / 2008
W e b s i t e : h t t p : / / w w w . i f a r . c a
DEALER TECH TOOL
REQUIRED
FOR PCM
PROGRAMMING
LOCATION
Black connector at Clock String
Black connector at Clock String
7 7 0 3 5 0 0 0 1 4 0
P.1 P.1
FIGURE
1
1
Copyright © 2006
FORTIN AUTO RADIO INC
7