When The Alarm Sounds; Disabling Alarms - Sangean DCR-200 Mode D'emploi

When the alarm sounds

The alarm icon will flash at the display when an alarm is sounding.
To cancel an alarm, press the Standby button to return to
Stand-by mode.
When the buzzer alarm activates, the alarm will start softly and
gradually increase in level. It will sound for 1 minute and silence for
1 minute at the selected time in repetition for up to 30 minutes unless
cancelled. The digital receiver will sound at the selected time for up to
60 minutes for other alarm types.

Disabling alarms

1. To disable a single alarm enter the alarm setup menu and rotate the
Tuning control until the desire alarm is showed on the display.
Press the Tuning control.
2. Rotate the Tuning control until "OFF" is showed on the display,
and press and release the Tuning control.
3. The display will return to previous mode and the chosen alarm will
now be disabled.
Note: To cancel a sounding alarm, simply press the Standby button.
29
1,2