Commissioning - holzkraft HWS 720 K Traduction Des Instructions D'origine

m Petrol engine
Engine oil
m Oil has been drained for shipping. Failure to fill engine sump with oil before starting engine will result in permanent damage and
will void engine warranty. Fill with engine oil according to the maintenance schedule.
Topping up with fuel
m WARNING
Petrol is highly flammable:
• Only store petrol in the designated containers.
• Only fuel the unit outdoors and do not smoke when filling.
• Petrol must be filled before starting the engine. While the engine runs or is hot, the tank cap must not be opened and petrol must
not be filled.
• If petrol overflows, no attempts should be made to start the engine. Instead, the machine must be removed from the area contami-
nated with petrol. Do not try to start the engine until the petrol vapours have evaporated.
• For safety reasons, petrol tank and other tank caps must be replaced if damaged.
• Never store petrol near a source of sparks. Always use a tested canister. Keep petrol away from children.
• Replace defective silencers.
• Open the petrol cap and fill the petrol tank with petrol up to the lower point of the tank filler neck.
• Use a funnel and measuring container for filling. Do not overfill the tank.
• Only use fresh, clean, unleaded fuel.
• Never mix oil with petrol.
• Purchase fuel in quantities that can be used within 30 days to ensure that the fuel is fresh.
Attention: Use standard unleaded petrol with max. 5% bioethanol component.
m WARNING
Always only use a safety petrol canister. Do not smoke when filling petrol. Remove any residual oil and petrol.
Switch the engine off before filling petrol and let the engine cool for several minutes.
Please also read the enclosed operating instructions of the petrol engine!

13. Commissioning

• Before commissioning observe the safety notes.
• All safety and auxiliary installations must be fitted.
• Check the rocker, which must return to the initial position independently. Check the saw blade for perfect fit and the correct direc-
tion of rotation.
• Functional check before start of work.
• To operate the saw, press the on / off switch.
• The saw is constructed solely for the cross cutting of firewood with max. 1 meter length.
• Regardless of the wood diameter, put only one piece with min. Ø 60 mm on the rocker.
• Use both hands to swing the rocker to the saw blade.
• Then place the rocker in the initial position.
• The wood to be sawn must not be fixed by hand.
• After the complete standstill of the saw, pull the mains plug or the ignition plug.
• Only carry out conversion, adjustment, measurement and cleaning work with the engine switched off. Wait until the rotating tool
has come to a standstill and remove the mains plug / spark plug connector.
page: 26
GB