Running A Program - Ibiza LC192DMX-MINI Manuel D'utilisation

Action
1. Select a FIXTURE button
2. Press the AUTO DEL button repeatedly until the MANUAL LED is lit.
3. Move the faders to change parameters for the selected fixture(s)
PAGE/SELECT A/B button: Use to switch between fader control pages (A: Ch1~8), (B: Ch 9~16) TAP DISPLAY button: Press
to toggle the output indicator on the LCD display between DMX values (0-255) and percentage (0-100)
Note: All changes made within MANUAL mode will be temporary and will not be recorded
3.2.1 Review Scene or Chase
This instruction assumes that you have already recorded scenes and chases on the controller. Otherwise skip this section and go to
programming.
Action (SCENE review)
1. Select a SCENE button (1-8) to review
2. Select any one of the 30 banks by pressing the BANK UP/DOWN buttons
3. Move faders to change fixture attributes Action
(CHASE review)
1. Select a CHASE button (1-6) to review
2. Press the TAP DISPLAY button to view the step number on the display
3. Press the BANK UP/DOWN buttons to review all scenes in the chase
Note: Make sure you are still in MANUAL mode
Programming
3.3
A program (bank) is a sequence of different scenes (or steps) that will be called up one after the other. In the FIXTURE, 30 programs can
be created with 8 scenes in each.
3.3.1 Entering Program Mode
Press the Program button until the LED blinks.
3.3.2 Create a Scene
A scene is a static lighting state. Scenes are stored in banks. There are 30 bank memories on the controller and each bank can hold 8
scene memories. The LC192DMX-MINI can save 240 scenes in total.
Action
1. Press and hold the PROGRAM button until the LED blinks.
2. Position SPEED and FADE TIME sliders all the way down.
3. Select FIXTURE(S) to begin adjusting the DMX values
4. Move faders to adjust parameters to the required setting for the fixture(s)
5. De-select a fixture to hold its DMX values
6. Adjust for all fixtures until all are set to the required state
7. Press the MIDI/ADD button
8. Select a BANK and then select a SCENE to store the scene
9. Press PROGRAM to store
10. Repeat the above process for up to 8 scenes in the bank
11. Hold the PROGRAM button to exit Program mode
Notes:
Deselect BLACKOUT if LED is lit.
Toggle the PAGE SELECT button to access channels 9-16. All LEDs flash to confirm storing a scene.
Shortcut: Press [PROGRAM] [FIXTURES]. Adjust [Faders] [BANK] [SCENE]. Press [PROGRAM] to store.
3.3.3

Running a Program

Action:
1. Use BANK UP/DOWN buttons to change Program banks if necessary
2. Press the AUTO DEL button repeatedly until the AUTO LED turns on
3. Adjust the program speed via the SPEED fader and the loop rate via the FADE TIME fader.
4. Alternatively you can tap the TAP DISPLAY button twice.
The time between two taps sets the time between SCENES (up to 10 minutes)
Note: Deselect Blackout if LED is lit.
©Copyright LOTRONIC 2018 LC192DMX-MINI 5