Maintenance - Roberts 10-481 Manuel Du Propriétaire

FULLY INFLATED PADS DO NOT CONTACT APPLIANCE:
1. Bridge the gap with wooden blocks, on top of pads until
within 1/4" of the front and rear contact points.
FLOATING APPLIANCE IS LOWER IN REAR THAN IN FRONT:
Stepping on the front of the inflated pads near the hose connections
will force more air to the rear.
1. Move the floating appliance forward 6" to 12".
2. Turn the blower off and ensure pads extend 4" from back of appliance.
FLOATING APPLIANCE IS TOO WIDE TO FIT THROUGH NARROW ENTRY:
Use side entry approach. If appliance is still too wide, you may have to
remove doors.
Rear

MAINTENANCE

Normal maintenance such as motor brush replacement, can be made at your
local service shop.
• Motor brush life is approximately 500 hours.
• Brushes should be checked between 200 to 250 hour intervals.
Side
Entry
Approach
Spacer
CUSTOMER SERVICE NUMBER: 1-866-435-8665
1/2"
Make sure blocks are under
crossbar or solid contact point
– 7 –
10-481_AirGlider_Chart-003.ai