Publicité
Les langues disponibles
Les langues disponibles
1.
Do not charge in an environment below 0°C and above 45°C, which may damage the battery and the
charger.
2.
Please turn off the switch before connecting the battery. If the switch is on, accidental connection of the
battery to the machine is likely to occur.
3.
Charge the battery only with the charger designated by the manufacturer. The use of other chargers may
4.
When the battery is not in use, keep it away from small metal objects such as paper clips, coins, keys,
5.
Do neither disassemble nor reassemble the battery.
6.
Do not use batteries with short circuit.
7.
Do not use the battery near any heat source.
8.
9.
10. Dot not insert any nail into the battery and hit or throw the battery with a hammer or foot.
11. Do not use batteries that are severely damaged or deformed.
12. Do not weld directly on the battery.
13. Reverse charging, reverse-pole connection and over-discharge of the battery is not permitted.
14. Do not connect the battery to power sockets or car cigarette lighter socket.
15. Do not use it on non-designated devices.
16. Direct contact with lithium battery is prohibited.
17. Do not place the battery in containers with high temperature and high pressure such as a microwave
oven.
18. Do not use any leaky battery.
19. Keep the battery away from children's reach.
20. Do not use or place the battery under the sun (or direct sunlight), otherwise it may cause the battery to
21. Do not use the battery in places with static electricity (>64V).
22.
return it to the sales outlet.
23. If skin or clothes are stained with electrolyte from the battery, please rinse with clean water.
24. If the electric pruning shears are not used for a long time, the battery needs to be charged for storage.
52
4.
4.1
Please cut off the power source of the shears before operation.
•
Refuel lubricating oil before using the blade or after it is used for more than 4h. For correct refueling
mentioned above, the blade needs to be opened.
Fueling hole in the pin hole of the blade on the back of the shears. Squeeze the lubricating oil from the oil
bottle into the fueling hole and cut nothing for several times to make the lubricating oil evenly distributed.
Please cut off the power source of the shears before operation.
Check the tightness of the blade before use. A blade with proper tightness will not swing left and right.
Proper tightness of the blade will make it labor-saving when pruning using the shears.
Caution: When the blade is closed, the blade should not have a lateral swing. Lateral swing is an abnormal
state, given it will create a gap between the two blades and causes the teeth of the gears to not properly
mesh, thus damaging the mechanical structure.
Please cut off the power source of the shears before operation.
grinding is still not clean after cleaning, it is recommended to replace the blade. The replacement steps are
as follows:
1.
For safety, please power off before replacement and remove the battery.
2.
Follow the steps below to replace the blade.
3.
After the replacement, clean it, connect the battery, check the power and close the blade.
Refueling place of
lubricating oil
53
Publicité
