Listening To The Sound - Sony SRS-BT100 Mode D'emploi

When pairing with a Bluetooth stereo audio source device that cannot display a list of
detected devices or that has no display
You may pair the device by setting both this unit and the Bluetooth stereo audio source device to pairing
mode. For details, refer to the operating instructions supplied with the device.
If pairing is not complete
Start over from step 1.
Tip
To pair with other Bluetooth devices, repeat steps 1 to 5 for each device.
Note
Passcode of this unit is fixed to "0000." This unit cannot be paired with a Bluetooth stereo audio source
device whose Passcode is not "0000."

Listening to the sound

This unit supports SCMS-T content protection. You can enjoy music, etc., from a device
such as a mobile phone or portable TV that supports SCMS-T content protection.
Check the following before operating the unit.
– The Bluetooth stereo audio source device's Bluetooth function is on.
– Pairing of this unit and the Bluetooth stereo audio source device is complete.
– If you have been listening to the sound from the source device connected to the INPUT jack, stop
playing on the device or turn off the device.
1
Press the 1 button to turn on this unit.
2
Start the Bluetooth connection from the Bluetooth stereo audio source
device.
3
Start playing on the Bluetooth stereo audio source device.
Note
If the source device has a bass boost function or equalizer function, set them to off. If these
functions are on, sound may be distorted.
4
Adjust the volume.
Set the volume of the Bluetooth stereo audio source device to moderate level, and press
the VOLUME +/– buttons on this unit.
Note
A beep sounds when the volume is set to minimum or maximum.
Notes
• In the following cases, you need to make the Bluetooth connection again.
– The power of this unit does not turn on.
– The power of the Bluetooth stereo audio source device does not turn on, or the Bluetooth function is
off.
– The Bluetooth function of this unit or the Bluetooth stereo audio source device is in sleep mode.
– The Bluetooth connection is not made.
• When the sound of a Bluetooth stereo audio device is being reproduced using the Bluetooth connection (when
both the power indicator (green) and communication status indicator (blue) light up), the sound from a device
connected to the INPUT jack cannot be heard. Terminate Bluetooth connection to listen to the sound of a device
connected to the INPUT jack.
12
US