Ferplast chef pro Manuel D'utilisation page 10

CHEF PRO
IT
During the stand-by phase, the yellow LED will intermittently flash slowly. This
EN
function allows you to use the feeder as a normal dispenser as and when required;
when you are going to be away, just press P1 and P3 to restore automatic operation.
• MANUAL
FR
Manual feeding, independent from programmed settings and stand-by.
• P1 + P2
RESET of the current programmed settings.
D
• BATTERY
When the red LED starts to intermittently flash slowly, the batteries are running low
and are only guaranteed to last for another twenty days.
NL
Warning!
If the RED LED intermittently flashes quickly, the feeder is malfunctioning!
ES
INSERTING THE FOOD
• Make sure that the feeder is in the rest position (food outlet hole closed by the
relative hatch integrated in the auger and by the front door);
• open the slide located in the upper part of the container, letting it run towards the
SK
outside (fig. C);
• fill the container with food (flakes or granules), trying not to pack in too much;
Warning!
If you turn the auger with the slide open, the feeder will jam. Remove and replace the
CS
slide correctly, starting it up again.
REGULATING THE AMOUNT OF FOOD TO BE SUPPLIED
There are  different hatches that can be applied to the container outlet, on the basis
HU
of the type of food being used:
•  hatches suitable for GRANULAR FOOD.
fig. D, we suggest using granules not bigger than  mm)
•  hatches to partially close the outlet hole (/ and /).
SV
Particularly suitable for FLAkED FOOD (fig. E).
After having chosen the hatch and loaded the food, we recommend testing it to make
sure that it works properly (MANUAL button), allowing you to assess whether the
selected quantity of food is correct (the amount of food that should be eaten by the
DA
fish in  minutes).
Warning! To ensure the right working of the product all the hatches must be correctly
inserted in their compartment, till you hear a click.
RU
MAINTENANCE: CLEANING THE CONTAINER
In order to allow for thorough cleaning, the food container can be easily extracted
from the motor body:
PL
• take it to the cleaning area;
• press the two side buttons in correspondence to the control panel at the same time
and slide out the whole container (fig. F);
0