Installation; Maintenance; Regulations - Diehl Metering IZAR RC 868 i G4 Guide Utilisateur

3.3 I
NSTALLATION
4 M
AINTENANCE
IZAR RC 868 i G4 requires no specific maintenance.


Do not clean it with solvents or abrasive cleaners, as these would damage the plastic shell.
If necessary, use a damp cloth or sponge.

Storage: The product may be stored in a dry place at temperatures between -20 °C and +70 °C.
Prolonged storage at high temperatures may cause a significant loss of autonomy.
5 R
EGULATIONS
The product complies with the European Directives as indicated on the EC Declaration of
conformity.
Recycling:
The transposed European Directives 2006/66/CE and 2012/19/UE and their
modifications supervise the actions necessary to limit the negative impact of waste
batteries and electrical and electronic equipment.
This product is subject to special collection and disposal. It should be deposited at an
appropriate facility to enable recovery and recycling. For further details about
recycling this product, please contact your Diehl Metering agency.
05/2015

If there is a cover on the meter, take it off
by pushing out the hinge pin (fig.8). If the
cover does not have a metal hinge,
remove it by hand.

Carefully clean the top of the register to
remove any traces of soiling.
fig.8
Position the IZAR RC 868 i G4 by

aligning the hinges up with each other
(fig.9).

Press the ring onto the module with
your hands only until it clicks into place.
Do not use a mallet or hammer. This is
an electronic component; handle with
care.
fig. 9
English
IZAR RC 868 i G4 | 7