Scsi Id Setting; Configuration Switches Setting - Sony SDT-S9000 Mode D'emploi

SCSI ID Setting

Configuration Switches Setting

14
Part 2. Preparation
The SCSI ID is set by the rotary switch on the rear panel. Press the + or -
buttons to move the number up or down, respectively.
As shipped from the factory, the SCSI ID is set to 0. Press the switch buttons,
if necessary, to select the SCSI ID number you require.
Precautions
• The SCSI ID must be different from IDs of the other peripherals on the
SCSI bus.
• As shipped from the factory, SCSI parity is enabled and Term power is ON.
Since the terminating resistor inside the drive is disabled, a SCSI bus
terminator must be connected to the SCSI bus before use.
• Before changing the SCSI ID setting, be sure to turn off the power with the
POWER switch on the front panel.
Sony SDT-S9000/S7000/S7200 has a set of configuration switches located
on its bottom side (Fig 2-2). These drives can be made ready to run in major
workstations by setting the configuration switches as shown in the following
table.
*1
with the SDT-S9000/S7000/S7200
Fig2-2 SDT-S9000/S7000/S7200 Configuration swiches
*1