Maintenance / Repair - ASCO Numatics REED A Série Notice D'utilisation

Détecteurs de position magnétiques atex pour rainure en t (types électronique ou contact reed)
Table des Matières

Publicité

Installation remarks / Installation
Adhere to the relevant national regulations and provisions.
Avoid electrostatic charging on plastic units and cables.
To avoid electrostatic charging steps must be taken to ensure the equalisation of potential
of metal parts (plug housing, fixing elements, etc.).
Protect the units and the cables efficiently against damage.
The units must not be installed in the partition between different zones.
The relevant installation regulations must be adhered to.
The wiring is indicated in the technical data sheet or on the type label.
The electrical connections (cables, wires, connectors) must be installed so that at least the
protection rating IP20 to IEC 60529 is met.
Misuse will invalidate the approval.
Special conditions for safe operation
Sensors of the types N-014559 und N-014568 may only be used in areas for which units of
the category 1G are required if intensive electrostatic charges caused by the application or
the process cannot arise.
Operation
To prevent the risk of personal injury or property damage, do not touch the sensor.
The sensor can become hot under normal operating conditions. If the sensor is easily
accessible, the installer must provide protection against accidental contact.
To prevent electrostatic hazard, clean with a damp cloth only. Do not use solvents.

Maintenance / Repair

The unit must not be modified nor can it be repaired. In case of a fault please contact the
manufacturer.
If needed, you can obtain data sheets or EC type test certificates from the manufacturer.
Declaration
We hereby declare that the position sensors of the types reed switch (ILS) and electronic
position sensors (MR) have been tested in our laboratory and that they meet the
fundamental health and safety requirements indicated in annex II of the European Directive
94/9/CE, and that they have the following EC type-examination certificate number: DEKRA
EXAM BVS 10 ATEX E023.
See our documentation at: www.asconumatics.eu.
UK
3

Publicité

Table des Matières
loading

Produits Connexes pour ASCO Numatics REED A Série

Ce manuel est également adapté pour:

Nam a sérieReed-fl5-00-a3 / n-014559Nam-fl5-00-a3 / n-014568

Table des Matières