Technical Data - DOMUS LINE DOTTI Manuel D'installation

INSTALLATION MANUAL

TECHNICAL DATA

Input voltage: 12–24Vdc
Output voltage: 12-24Vdc
Maximum applicable load: 36W (with 12Vdc power supply)
72W (with 24Vdc power supply)
WARNINGS
Safety is guaranteed if these instructions are followed so they must be kept.
Installation may require involving qualified personnel. Before installing the
luminaire ensure that the environmental conditions are in compliance with
and suitable for product characteristics. Before any operation on the
luminaire, disconnect the mains voltage.
INSTALLATION:
- DOTTI is a device for installation on the surface of panels made of wood,
plastic, granite etc. with the exception of metals such as steel, aluminium,
iron and similar.
- DOTTI can be installed with the cables in an axial or radial position in
relation to the mounting surface. For installations with the power cable in
the axial position, drill a ø ≥ 9mm hole in the mounting surface as shown in
the example in figure 1. For special requirements, it is nonetheless possible
to drill the power cable outlet hole in other positions as long as they do not
EN
interfere with the integrity of the cable and/or connector installed on it.
- Fix the bracket (A) in the required position using the screws supplied (B).
- Connect DOTTI only to a safe power supply with 12Vdc or 24Vdc stabilised
voltage (sold separately) and with power at least 10% higher than the total
load. For the total load calculation check plate data printed on the product
label.
- For connection to a 24Vdc power supply (figure 2) insert connector (C) on
the DOTTI input cable (IN) to one of the free slots on the distributor (N) on
the Converter secondary cable; then connect connector (D) on the DOTTI
output cable (OUT) to connector (E) on the Micro-24 distributor cable (F).
- For connection to a 12Vdc power supply (figure 3) use the adapter cable (G)
and the Micro12 distributor (H) sold separately. Connect the DOTTI input
cable (IN) to the adapter cable (G) and then to one of the free slots on the
distributor (I) on the power supply secondary cable; then connect the
connector (L) on the DOTTI output cable (OUT) to connector (M) on the
Micro12 distributor cable (H)
- DOMUS Line guarantees the product only when powered with Converters
supplied by DOMUS Line.