Dmx Address Mode; Switch Pack Mode; Dimmer Pack Mode - EuroLite EDX-1 Mode D'emploi

6.1 DMX Address Mode

1. The Segment Display shows the last selected DMX address.
If the last DMX address was 123, then the Segment Display will read 123.
2. Change DMX address via Up and Down buttons.
Change DMX address quickly by pressing and holding down the buttons.
Once the DMX address is selected, it is automatically stored into memory.
NOTE: During DMX addressing, output is disabled.

6.2 Switch Pack Mode

1. After entering the complete DMX address, press Menu button to enter the next level.
2. Press Up and Down buttons.
The Display shows "s---". Now the switchpack can be controlled via DMX.
3. Press Menu button to enter Switch pack mode. Switch pack mode consists of Switch
On (S-on) and Switch Off (S-of). In the Switch On mode, output and lights of the device
is turned on, regardless of DMX signal.
In the Switch Off mode, output is turned off and the device is in Standby-mode.
4. Press the Up and Down button to change between
Switch On and Switch Off.
5. Once the Switch Pack is selected, press Menu button several times to return to DMX
Address mode.

6.3 Dimmer Pack Mode

1. Press Menu button to enter next level.
2. Press Up and Down buttons
The Display shows "d---".
3. Press Menu button to enter Dimmer Limit mode.
4. Press the Up and Down button to change the value within the range of 30-100.
Each tap will change the value once, pressing and holding down will change
the value quickly. Once the Dimmer Limit is selected, it will be stored automatically.
5. Press Menu button to enter Dimmer Preset mode.
6. Press Up and Down buttons to change the value within the range or 00-100. Each tap will
change the value once, pressing and holding down will change the value quickly.
Once the dimmer Preset is selected. it will be stored automatically.
17/34 00026401.DOC, Version 2.1