Gardeo GTDE1842I-2L Traduction Des Instructions D'origine page 38

n) Never put the hands or feet close
to or under the rotating parts. Never
allow the ejection opening to
become obstructed.
o) Do not transport the machine
when the power supply is applied.
p 1) Stop the machine and remove
the electric plug from its socket.
Check that all moving parts have
stopped completely.
p 2) Stop the machine, and remove
the isolating device. Check that all
moving parts have stopped
completely:
− before leaving the machine,
− before cleaning blockages or
unblocking the trough,
− before inspecting, cleaning or
repairing the machine,
− after hitting a foreign object.
Inspect the machine to detect any
damage and make repairs before
restarting and using it.
If the machine starts to vibrate
abnormally (check immediately):
− inspect the machine to check
whether it is damaged,
− repair or replace any damaged
part,
− check that parts have not
become loose and tighten them if
necessary.
4 Maintenance and storage
a) Keep all the nuts, bolts and
screws tight to as to be certain that
the equipment is in good working
order.
b) Check the collection box
frequently for wear or deterioration.
c) Replace worn or damaged items
so that the machine remains safe.
d) On multi-blade machines, take
precautions, because rotation of
one cutter can lead to the rotation of
all the others.
e) Take care, when adjusting the
machine, to avoid trapping fingers
between moving blades and their
fixed parts.
f) Always allow the machine to cool
before storing it.
g) During routine maintenance of
the cutter, take care, even if the
power supply is cut off, as it could
still be moving.
h) Replace worn or damaged items
so that the machine remains safe.
Only use spare parts and original
accessories.
5 Recommendation
We recommend supplying the
machine via an RCD [Residual
Current Device] with breaking
current less than or equal to 30 mA.
Remove the plug from the
socket:
– whenever you leave the
machine,
– before clearing a blockage,
– before checking, cleaning or
working on the machine,
– after striking a foreign object.
Inspect the machine for damage
and make repairs as necessary,
– if the machine starts to vibrate
abnormally (check immediately).
Power supply
The voltage indicated on the
rating plate must correspond to the
voltage of the power source.
We recommend that this
equipment is only connected into a
socket which is protected by a
circuit-breaker that would be
actuated by a 30 mA residual
current.
Only use or replace power supply
cables for this unit which
38