Using The Tool - HÖFFTECH 008051 Manuel D'utilisation

USING THE TOOL

1. Connect the socket of the mini engraver to the plug of the 12V mains adaptor and
insert into a 13amp socket and switch on. The tool must turn clockwise.
2. Contact the material lightly. Do not press hard on the tool while working as this will
cause the motor to stall. Allow the tool to work at its own pace. It is better to make
repeated actions to remove large amounts of material rather than attempt to remove
it in one ao and overheat the tool
3. It is advisable to practice using the tool on scrap pieces of material to determine the
required pressure and action to achieve the desired finish and effect.
4. After finishing, switch the tool off and allow to cool down before storing in a safe, secure
place.
MAINTENANCE
Always unplug the item from the power source before maintenance.
All plastic parts should be cleaned with a soft damp cloth. Never use solvents to clean plastic
parts because these can cause damage to the item. Ensure that no water gets into the machine.
If anything unusual happens during use of the item, turn the item off. Pull the plug from the
power source and check the item thoroughly. If necessary, have the machine repaired by a
qualified technician before using it again.
STORAGE
Store the machine, the manual and accessories in the original packing. This way you always have
the necessary information on hand. Store the tool in a dry environment.
DISPOSAL
Do not dispose of this tool in the household waste. According to the European
standard 2012/19/EU for the disposing of electrical equipment (WEEE), it should
be taken to your local waste collection station and offered for recycling.
J.C.J.C. IMPORTS, P.O. BOX 2007, 1801 EA ALKMAAR, THE NETHERLANDS
12