Erasing Tracks - Eagletone DPW 100 Guide De L'utilisateur

PLAYBACK
1. The Track LED indicators will show which tracks contain recorded data. If you do not
wish to hear one of the two Tracks, press the corresponding TRACK button to turn that
track off. Its LED indicator will turn off.
2. Press the PLAY/STOP button to hear the recorded track(s). The PLAY indicator lights
up and the beat indicators will flash per the beat pattern and tempo.
You can change the tempo of your recorded track by pressing the TEMPO button while
the recording is being played back.
You may also accompany the recorded tracks on the keyboard while the recording is
playing back.
Note: If the metronome is turned on before pressing the PLAY/STOP button to play back
the recorded music, the metronome will sound with proper tempo and beat pattern which
performed during your recording.
3. Press the PLAY/STOP button to stop the playback.
Playback will also stop automatically when the recording reaches its end.
4．In the step 2, you can change the tempo of the playing back temporarily. You could
also change the tempo for the recorded tracks permanently:
adjust the new tempo value
-
- hold the REC button and press the PLAY/STOP button
Tracks will playback at the new tempo and this tempo will be set for the tracks.
Beat pattern cannot be changed.

ERASING TRACKS

To erase the music recorded on the tracks:
1. Press and Hold the REC button down.
2. Press the track button that you which to erase while you continue to hold down the REC
button. This will immediately erase the existing data from your previous recording.
3. Release the REC button (the track and REC indicators are blinking).
4. Press the track button again (the indicators will go off).
5. Repeat Steps 1 through 4 until all the tracks that you desire are erased.
R EC OR D
T RA CK 2
P LA Y / ST OP T RA CK 1
16
R EC