Installing Or Removing Saw Chain - Makita DUC122 Manuel D'instruction

ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and the
•
battery cartridge is removed before carrying out
any work on the tool.

Installing or removing saw chain

CAUTION:
Always be sure that the tool is switched off and the
•
battery cartridge is removed before installing or
removing the saw chain.
Always wear gloves when installing or removing
•
the saw chain.
Use only saw chain and guide bar with bar tip
•
designed for this chain saw (see the Extract from
the spare parts list).
In order to prevent kickback, do not remove the
•
bar tip or replace the guide bar with one without a
bar tip.
1
008566
Loosen the screw by turning counterclockwise the knob
until the sprocket cover comes off.
Remove the sprocket cover.
Remove saw chain and guide bar from the tool.
1
2
008568
Fit in one end of the saw chain on the top of guide bar.
At this time, fit the saw chain as shown in the figure
because it rotates in the direction of arrow.
1. Sprocket cover
2
2. Knob
1. Cutter
2. Guide bar
3. Arrow
3
2
013690
Place the saw chain so that the spring is positioned
inside it and fit in the other end of saw chain around the
sprocket as shown in the figure.
1
013691
While turning the guide bar counterclockwise, install it
so that the end of guide bar contacts the spring.
2
3
008569
Insert the hook of sprocket cover into the hole in the tool
and then place the sprocket cover on the tool.
8
1. Spring
2. Sprocket
1
1. Spring
2. Guide bar
2
1. Sprocket cover
1
2. Hook
3. Hole