PoolMaster 35600 Mode D'emploi page 2

Step 3
• Once steps 1 and 2 are complete the Organizer is ready to be mounted.
Please see the below mounting options.
Mounting Option 1
• If mounting using the Support Brackets: Faceone Bracket so that the circular support knobs are facing
the back of the Organizer Body. Fit the knob through one of the keyhole-shaped openings on the
Organizer Body and lift up on the Bracket to set in place. (See figure 3) Repeat with second Bracket. The
Organizer is now ready to hang.
In order to ensure that the Brackets stay securely in place, you will need to use some force to snap the
support knobs into the top portion of the keyhole-shape opening on the Organizer Body. It is
recommended to use any standard household lubricant, such as W-D 40, petroleum jelly, a silicone-based
lubricant, etc. Please also view our video online at poolmaster.com ( item #35600) for tips on how to
secure the Brackets.
Figure 3
Mounting Option 2
• If mounting directly onto a wall/surface:
mounted to and make a mark at the top of the keyhole shaped opening. Setyour screws using a Philips
Head Screwdriver or Power Drill at these marked locations, leaving each screw extended about a half inch
from the wall/surface. Set the Organizer so that it rests on each screw at the top of the keyhole shaped
opening. Once this is done, you may finish setting your screws, drawing the Organizer tight against the
wall/surface. (see figure 4)
NOTE: If attaching the Organizer to a hollow wall/surface, such as drywall, use the provided Drywall
Anchors in conjunction with the screwsfor added security.Werecommend using a5/16" Drill Bit.
Figure 4
POOLMASTER
CACJCZI
Place the Organizer Body against the wall/surface it will be
Your new Pool Tool Organizer can hold up to 901bs!Enjoy
poolmaster.com