Dorman 13723 Mode D'emploi

INSTRUCTIONS
KEYLESS ENTRY
REMOTE
13723
BEFORE YOU BEGIN:
• Always wear proper safety
equipment when performing repairs.
• Ensure at your point of purchase
that this part fits your exact
vehicle configuration.
• Reference the appropriate service
manual for your vehicle. If you do
not have a service manual, and do
not have the training or experience
to perform the necessary
procedures correctly, seek the
services of a qualified technician.
NEED HELP?
Please call our Technical Support
team for assistance from our team of
certified automotive experts.
1-866-933-2911
© 2025 No reproduction in whole or in part without prior written approval.
13723_Instructions_v2
NOTE: Use first procedure for
vehicles with Driver's Information
Center buttons (not just the
odometer trip reset stem).
NOTE: This procedure will erase all
previously learned transmitters.
All currently programmed and new
remotes must be reprogrammed to
vehicle together in the same session.
INSTRUCTIONS
FOR VEHICLES
WITH DRIVER'S
INFORMATION
CENTER BUTTONS
STEP 1:
Insert key and turn key to on position
without starting vehicle.
STEP 2:
Press and release the vehicle's information
button until "PRESS TO RELEARN REMOTE
KEY" displays.
STEP 3:
Press the set/reset button until "REMOTE
KEY LEARNING ACTIVE" displays.
STEP 4:
Press and hold lock and unlock buttons
on first keyless remote simultaneously for
approximately 15 seconds. A chime will
sound indicating successful programming.
STEP 5:
To program additional remotes, repeat Step
4. Up to eight remotes can be programmed
to this vehicle.
STEP 6:
To exit programming mode, turn key off and
remove key. Test remote(s).
Dorman Products, Inc. Corporate Office and Customer Service: 1-800-523-2492.
Disclaimer: It is impossible in these instructions to account for all possible circumstances or situations that you may experience when at-
tempting to install this product. Please consult with a qualified auto technician before attempting to perform any work you are not qualified to
do. Automobiles can be hazardous to work on; be sure to take all necessary safety precautions. Failure to do so may result in property damage
or personal injury. Certain motor vehicle standards and performance requirements may apply to your motor vehicle (such as Federal Motor
Vehicle Safety Standards by the National Highway Traffic Safety Administration). Be sure that your work is performed in accordance with such
standards and that you do not disable any motor vehicle safety feature.
INSTRUCTIONS
FOR VEHICLES
WITHOUT DRIVER'S
INFORMATION
CENTER BUTTONS
STEP 1:
Turn key to on position without starting
vehicle.
STEP 2:
Press and release trip odometer reset stem
until "RELEARN REMOTE KEY" displays.
STEP 3:
Press and hold trip odometer reset stem for
three seconds. The message "REMOTE KEY
LEARNING ACTIVE" will display.
STEP 4:
Press and hold lock and unlock buttons
on first keyless remote simultaneously for
approximately 15 seconds. A chime will
sound indicating successful programming.
STEP 5:
To program additional remotes, repeat Step
4. Up to eight remotes can be programmed
to this vehicle.
STEP 6:
To exit programming mode, turn key off and
remove key. Test remote(s).
PAGE 1 OF 3