Kimex 163-4320 Manuel D'utilisation page 16

First time installation
System Menu Contents
Language
Date/Time
Sources
More
Menu Timeout
Standby Led
Software version
Auto Display
OFF
Video Wall
Settings
CEC
CEC Auto Power
On
Speakers
Quick Standby
DP Stream
Setting (*)
USB Auto Play
Highlight and press OK to perform First Time Installation and reset all settings to factory
settings. You will need to enter the correct PIN to carry out this operation.
Note: Enter the PIN you have defined during the First Time Installation process.
Sets the OSD menu language preference.
Sets date and time.
Enables or disables selected source options. There will be Regular, Enhanced and
Disabled options available for HDMI sources, if your Display supports Ultra HD. Regular
and Enhanced options are affecting the colour settings of the selected HDMI source.
To be able to watch 4K images from an HDMI source related source setting should be
set as Enhanced if the connected device is HDMI 2.0 compatible. Set as Regular if
the connected device is HDMI 1.4 compatible. Set accordingly or disable the related
HDMI source by setting as Disabled.
Note: HDMI cables which are longer than 5 metres and which are not HDMI certified can cause display
problems.
Displays other setting options of the Display.
Changes timeout duration for menu screens.
Enables or disables the functionality of the standby led. If disabled the led will not function.
Displays current software version.
Sets the desired time for the Display to automatically go into standby mode when not
being operated.
Press OK to open the Video Wall Settings menu screen. Row Count, Column Count,
Cell and Offset options are available.
With this setting you can enable and disable CEC functionality completely. Press Left
or Right button to enable or disable the feature.
This function allows the connected HDMI-CEC compatible device to turn on the Display
and switch to its input source automatically. Press Left or Right button to enable or
disable the feature.
To hear the Display audio from the connected compatible audio device set as Amplifier.
You can use the remote control of the Display to control the volume of the audio device.
If this feature is enabled the Display can be turned on again with the RS232 and Lan
commands if it is turned off through it. Press Left or Right button to enable or disable
the feature.
Sets the DisplayPort stream type. MST and SST options are available.
(*) This menu item appears only when the input source is set to DP.
Using this option you can set your Display to start playing the media content installed
on a removable device automatically. Refer to USB Auto Play Feature section for
detailed information.
English - 14 -