Cleaning And Storage - Otto PC-P008E Mode D'emploi

EN

Cleaning and storage

ATTENTION!
■ Ensure that the device has been deactivated before you clean it!
■ Never immerse the device, the mains adapter, the rechargeable battery or the cable
in water or other liquids.
■ The device may not be connected with the mains adapter when cleaning the dust
bin.
■ Never use soap or other cleaners to clean the dust and HEPA fi lter. Otherwise this
would damage the fi lters.
■ The fi lters are not suitable for the washing machine, dishwasher or dryer! Only air
dry the fi lters and do not in any case use a hair dryer.
■ Only put the device back together once all parts are completely dry!
■ Do not use any corrosive or abrasive cleaners to clean the housing. They could
damage the surface. If needed, clean the housing with a damp, soft cloth.
Emptying the dust bin and cleaning the fi lters
1. Take the dust bin off of the device by turning it approx. one quarter revolution coun-
terclockwise and pulling it out.
2. Push the release button on the dust bin and empty the dust bin over a waste bin.
4. If necessary, clean the dust bin and the dust fi lter with clean, lukewarm water.
5. Allow all parts to dry completely before assembling them.
ATTENTION: Do not in any case insert the dust fi lter if it is still moist. Reverse
the steps to assemble them. Make sure that the catches on the dust bin are inserted
into the corresponding recesses on the main unit. Otherwise, the dust bin will not
correctly lock into the device.
6. Store the device and accessories in a dry area out of the sun that is not accessible
to children and animals.
If you do not want to use the device for a prolonged period, remove the recharge-
able battery to stay on the safe side (see section "Removing the rechargeable
battery").
20
3. Pull the fi lters out of the dust bin: Turn the dust fi lter
approx. one quarter turn counterclockwise and remove
both fi lters. Knock all parts out over a rubbish bin and
brush them off if necessary.