HOMCOM 800-239V80 Manuel D'instructions page 6

- INSTRUCTIONS
1.Note
- Place your refrigerator where the plug is easily accessible.
- Keep the refrigerator out of direct sunlight.
- Do not place it next to heat-generating appliances.
- Do not place it directly on the ground; use a suitable stand.
2.Very important
- The refrigerator performs best at 16-32°C. It should be powered off if the
ambient temperature is below 10°C.
- After plugging it in, let it cool for 2-3 hours before adding beverages.
- Good ventilation is crucial to prevent damage to the internal PCB and to extend
the refrigerator's life.
- The refrigerator has an automatic defrosting system, so manual defrosting is not
needed.
3.Power supply
- Connect the refrigerator to a properly earthed socket, following relevant country
regulations.
- Check the voltage and frequency on the data label (located on the side) to
ensure they match your local supply. If they don't, do not plug it in.
VENTILATION
When setting up a TE cooler, ensure proper ventilation by following these
guidelines:
1. Allow at least 200cm³ for ventilation.
2. Keep at least a 200m gap between the cooler and the wall.
3. Ensure at least 50mm of space at the back for airflow.
4. Air passing through must not be preheated.
5. Consider the entire cooling system for proper ventilation.
6