Elem Garden Technic BV2444 Traduction Des Instructions D'origine page 22

During operation, do not reach into the feed
intake or the discharge chute. The machine
runs on for a few seconds after being switched
off.
Before switching on, the machine must be
assembled according to the enclosed instructions.
It is recommended for increased electrical safety to
use a Residual Current Device (RCD) with a tripping
current of not more than 30 mA. Always check your
RCD every time you use it.
Use only extension cables that are intended for
outdoor use and are protected against splashes of
water.
Do not touch the plug or socket with wet hands.
Do not drive over, crush or stretch the cable.
This appliance is not intended for used by persons
(including children) with reduced physical, sensory
or mental capabilities, or lack of experience and
knowledge, unless they have been given
supervision or instruction concerning use of the
appliance by a person responsible for their safety.
Children should be supervised to ensure that they
do not play with the appliance.
Other persons and animals should remain at a
distance of 3 metres or more when the machine is
being used. The operator is responsible for third
persons in the working area.
Become familiar with the owner's manual before
attempting to operate this machine.
Avoid wearing loose-fitting clothing, hanging cords
or ties.
Only operate the machine in open space (eg not too
close to a wall or other fixed objects) and on a firm,
level surface.
Do not operate the machine on paved or gravel
surface where ejected material could cause injury.
Before starting the machine, check that all screws,
nuts, bolts and other fasteners are properly secured
and that guards and screens are in place. Replace
damaged or unreadable warning and operating
labels.
Before starting the machine, make certain that the
feed intake is empty.
Keep your face and body away from the feed intake.
Do not allow hands or any other part of the body or
clothing inside the feed intake, discharge chute or
near any moving part. Switch off the machine before
attaching or removing the bag.
Keep proper balance and footing at all times. Do not
overreach.
Never stand at a higher level than the base of the
machine when feeding material.
Always stand clear of the discharge zone when
operating the machine.
When feeding material into the machine be
extremely careful that pieces of metal, rocks,
bottles, cans or other foreign objects are not
included.
If the cutting mechanism strikes any foreign object
or if the machine should start making any unusual
noise or vibration, immediately switch off and allow
the cutter to stop.
Remove the plug from the mains
supply and take the following steps:
– Inspect for damage.
– Replace or repair any damaged parts.
– Check for and tighten any loose parts.
Do not attempt to repair the machine unless you are
qualified to do so.
Do not allow processed material to build up in the
discharge zone; this may prevent proper discharge
which can result in kickback of material through the
feed intake.
If the machine becomes clogged, switch off and
allow the cutter to stop. Remove the plug from the
mains supply before clearing debris.
Keep all guards and deflectors in place and in good
working condition.
Do not tamper with the motor speed control settings.
ELEM GARDEN TECHNIC
Contact a
sav@eco-repa.com
approved service agent if a
problem exists.
Keep the motor cooling vents clean of debris and
other accumulations to prevent damage to the motor
or possible fire.
Do not transport the machine while the motor is
running.
Switch off, allow the cutter to stop and remove the
plug from the mains supply whenever you leave the
work area.
Do not tilt the machine while it is running.
22