Alecto DVC-215IP Mode D'emploi page 29

4 RESET.
When contact with the camera is no longer possible and you can no longer
determine what the IP address or the port number no longer corresponds, you
can externally reset the camera to restore the default factory settings.
For this, a reset button is placed on the cable of the camera. Press and hold this
button for at least 10 seconds after the camera is switched on.
The camera can then only be reached via the UTP network input. Use a UTP
cable to connect the camera to your router. Now follow the registration process,
see 2.3.
5 TIPS AND WARNINGS
5.1 GENERAL
•
Read the user manual carefully and follow all instructions.
•
Never place or use the adaptor in a wet or moist room or environment.
•
Take care of proper heat dissipation; never cover the camera unit and/
or the power supply adapter(s), and do not place them directly beside a
heat source. The camera and adaptor already become warm themselves
during operation.
•
Only use the supplied connecting cables; connecting cables of a different
type can be dangerous or cause damage to the electronics.
•
Take care that the cables and the adapter do not get damaged, and
prevent that they cause tripping or falling.
•
Never disassemble the camera unit and/or adaptor; this may only be
performed by qualified personnel.
•
The video connection occurs via the public internet and is secure
according to the current standards, but can still be hacked. We are
not liable for this in any way. We advise you to instantly change the
password, preferably using a combination of letters, numbers and special
characters.
29