Bond PGF6501-1 Mode D'emploi page 7

ASSEMBLY INSTRUCTIONS
1. Check that the control knob (G) for the gas
supply system is turned to the 'OFF' position
before starting any assembly.
2.
Attach handle (C) to the lid (A) using 2 pcs
washers (BB) and 2 pcs M6 x 16 screws (AA).
3. Remove the rubber cap on the electronic igniter
(H) by unscrewing and slide battery (D) into the
battery slot. Make sure the positive side of the
battery faces outwards. Screw the electronic
igniter cap (H) over the battery tightly.
OFF
ON
G
C
BB
AA
H
1-866-771-2663 | Page 7
OFF
ON
D