General Guidelines - Songmics Vasagle Rvt619 Instructions D'assemblage

EN
General
Guidelines
Please read the following instruction carefully and use the
product accordingly.
Please keep this manual and hand it over when you
transfer the product.
This summary may not include every detail of all variations
and considered steps. Please contact us when further
information and help are needed.
Warnings
Children are not allowed to assemble the product. During
assembly, keep all small parts out of the reach of children
as they may be fatal if swallowed or inhaled.
Children are forbidden to climb or play on the product to
avoid serious bodily injury caused by the toppling.
Keep plastic packing bags out of reach of children to
avoid any potential danger, such as suffocation.
The total maximum static load capacity of the product is
91 kg (200 lb). Do not place overweight items on it.
The product should be attached to the wall with the
included anti-tipping kit to prevent personal injury caused
by accidentally tipping over.
30
Notes
The product is intended for domestic use only. The product must be assembled and used in accordance with the
provisions of the manual. Personal injury and/or damage to product may occur if products are used outside of their
intended purposes and/or if products have been changed/modified from their original design. The seller does not
assume any responsibility or liability with respect to any injury/damage caused by incorrect assembly or improper
use.
Avoid long-term exposure to humid environments to prevent mildew.
Keep the product away from fire sources and high temperatures. Do not expose the product to direct sunlight.
Do not place any hot objects on the surface of the product.
If there are any defective or missing parts after unpacking, please cease assembly immediately and contact us.
Please assemble the item on a spacious surface and do not place the unwrapped product directly on the ground to
avoid product damage.
Please do not stand or sit on the wooden boards.
Please wear gloves during the assembly and/or disassembly process to avoid scratches from any sharp edges.
Please match the corresponding part and fitting based on the part number in the manual.
If the part does not match with the fitting, please check the piece as specified in this manual.
During assembly, first loosely align all screws with the corresponding pre-drilled holes and then tighten the screws
one by one.
Periodically inspect screw tightness while the product is in use. If necessary, retighten to ensure structural integrity.
If you accidentally spill water or another liquid on the surface, immediately wipe clean with a dry towel.
Please keep the product away from sharp, pointed objects and corrosive substances to prevent product damage.
Please place this item on level, solid ground during use.