Serta Motion Air Guide D'installation

PART LIST
Before discarding the packing materials, ensure all the parts
are accounted for. Some parts may be attached to the base
or inside boxes. Please inspect carefully.
Long Bolts (2) (4) Washers
Short Bolts (2) (4) Nuts
STEP 1- Unfold the base
Always use two people when setting up, moving or flipping base.
Unfold the base so that the bottom side is facing up.
STEP 2 - Secure hinge with short bolt
a. Gently lift the folding
connection points. Next,
Insert a short bolt through
the hole in the hinge of the
frame.
b. Secure the end of the short
bolt with a washer and a nut.
c. Tighten the bolts with the
box wrenches provided.
STEP 3 - Secure hinge with long bolt
a. Gently lift the folding
connection points. Next,
insert a long bolt through
the hole in the middle of the
hinge of the frame.
(2) Box Wrenches
(6) Legs
TRI-FOLD KING
INSTALLATION GUIDE
b. Secure the end of the long
bolt with a washer and a nut.
c. Tighten the bolts with the
box wrenches provided.
STEP 4 - Screw in the legs
Attach legs by screwing them into leg threads. Do this on all four
corners and on each side in the middle. Note that alternative leg
heights of 3" increments may be achieved by unscrewing the leg
segments. Carefully flip base over onto its legs.
Important: Two people are required to move bed base. Do not drag
frame across the floor or rest frame on its side, as excessive pressure
may damage legs.
STEP 5 - Install the mattress retainer bar
Insert each end of the mattress retainer bar into the holes located on
the foot section, and lay it down so that it rests on the edge of the
base.
V001_R02_06/2020
35009058