Reliable ARIA 100SP Guide D'utilisation page 18

TROUBLESHOOTING
CAUTION: Prior to using or maintaining your steam press, isolate the unit by
removing the cord from the power socket.
PROBLEM
LED is not on
No heat
No steam
Buttons are not working
properly
E1 Warning
E2 Warning
E3 Warning
Steam burst output is weak
15
SOLUTION
• Ensure that the press power cord is correctly plugged into
a 120V AC power outlet only.
• Ensure circuit breaker is operational.
• Try operating the press from another power outlet.
• Make sure the temperature has been selected.
• Pressing plate has been left in a raised position for more
than 20 minutes and automatic shut-off has engaged.
• Water may be low, refill water tank.
• Temperature setting is too low to activate steam. Select
a higher temperature and wait for the ready light to illumi-
nate before steaming.
• Unplug the unit from the power outlet for 5 minutes then
plug back in.
• The pressing plate and ironing board have been held
together for too long. Separate the plate from the board
and either unplug your unit then plug back in or turn the
press off then on again to restart the unit.
• Automatic shut off feature warning. If the press is left
unused for too long, a beep and warning will appear. After
20 minutes of no use, the press will automatically shut off.
• There is a loose wire in the thermostat. Unplug your press
and call technical support.
• Pressing plate needs to be cleaned. Refer to cleaning
section of the manual for the correct procedure.