GLW CS 60 Mode D'emploi page 52

MALFUNCTION
Display
08/2012
Malfunction/Message
Sensor for rear turning
point is not actuated
although the stripper
should be in start
position.
Max. time for stripping is
exceeded.
Max. motor current is
exceeded.
Waste tray was removed
during the operating
cycle.
Troubleshooting
1. Switch off the stripper and, once the
display has gone blank, switch the stripper
on again.
1. Check the settings on the display.
2. Switch off the stripper and, once the
display has gone blank, switch the stripper
on again.
1. Check the settings on the display.
2. Switch off the stripper and, once the
display has gone blank, switch the stripper
on again.
1. Switch off the stripper and, once the
display has gone blank, switch the stripper
on again.
18