Publicité
SPECIFICATIONS
Working Load Limit
Height Lowered
Height Raised
IMPORTANT SAFETY INFORMATION
The use of a vehicle jack has inherent dangers to avoid risk of personal injury or
property damage make sure you are fully aware of the operating instructions for this
product, the recommendations in the vehicle owner's manual for jacking of your vehicle
prior to lifting the vehicle. Do not exceed maximum lifting capacity of this jack. This jack
is intended for automotive use only. Be aware that large or heavy vehicles may exceed
jack's stated capacity check vehicle owner's manual or contact the vehicle
manufacturer. Do not use for any other purpose except the raising and lower of
vehicles, never use to raise any structure or building. Do not lift any human load and
never ride on jack.
UNPACKING AND ASSEMBLING JACK
Unpacking Carton
Place carton in a clear, open area such as garage floor. Remove jack and three handle
pieces from carton.
Assembling Handle
Insert handle piece (A) into middle handle
piece (B) into handle piece (C) making sure
holes line up for retaining clips. With the jack
sitting on its wheels on a flat surface, slide
assembled handle into handle base, rotate
until the square-shaped hole slips over shaft
in handle base. Check again to be sure
handle is fitted properly using finger pressure
only. Loosen 1/2 turn handle should rotate
easily.
At the rear of jack a large metal clip holds handle base flat against the jack. While
keeping handle pushed down in compressed position, carefully remove clip by pulling
out. Release pressure on handle base and discard.
Testing Handle Operation
Briefly test jack operation as follows BEFORE using to lift any Load. Twisting handle
tightens or releases the valve which allows jack to be raised and lowered. To raise jack,
twist handle completely clockwise until it stops. Do not force or tighten beyond this
point. Pump the handle a few times to raise the jack about halfway. If jack does not
begin to rise after a few pumps, check to be sure handle is correctly inserted into
handle base and is fitted over hex shaft. With jack raised, twist handle slowly
counterclockwise to lower jack.
A normal hissing sound may be heard as jack lowers and pressure in hydraulic cylinder
is released.
3TON
75mm
500mm
To operate the jack, insert
the handle end into the
handle socket and pump the
jack handle to raise the load.
3
To operate
release valve
Close
Open
Load
Publicité
