Frigidaire FFUE2024AW Point De Départ

BEFORE YOU START
SET UP YOUR FREEZER
Prior to using the freezer, make sure it is located on a fl oor that is level and strong enough to support it fully loaded. Check out
INSTALLATION in your User Manual to see how to set the anti-tip bracket.
BEFORE OPERATING FOR THE FIRST TIME
Clean the inside of your appliance before using it. See the CARE AND CLEANING section in your User Manual.
YOU'RE IN CONTROL
Set your freezer temperature
It's easy! When fi rst turning your appliance on, adjust to Recommended. Some models have a green LED
Power On Light projected on the fl oor. Note: this light will fl ash continuously until the freezer reaches the
selected temperature. To ensure safe food storage, allow the appliance to operate with the door closed for at
least 8 hours before loading it with food. If necessary, we recommend you adjust the temperature gradually,
in small increments, allowing the temperature to stabilize.
1. Adjusting the appliance temperature control to OFF turns off the
compressor and prevents the appliance from cooling but does not
disconnect the power to the light bulb and other electrical components.
To turn off power to your appliance, you must unplug the power cord
from the wall outlet.
2. For warmer temperatures, adjust the setting to Cold. For colder
temperatures, adjust the setting to Coldest.
3. The control can be left at the factory preset (Recommended) or adjusted
as desired.
4. If the temperature inside the cabinet increases, the red High Temp* light
will illuminate and the alarm will sound.
5. The Freeze Boost* mode quickly drives the appliance to a colder temperature and stays active for up to 24
hours before automatically deactivating or being manually exited.
6. Pressing the Temp* button will allow you to scroll through the fi ve temperature settings from Cold (top) to
Coldest (bottom), and then loop back to Cold.
*Refer to your User Manual for detailed information.
QUICK CARE
A LITTLE LOVE GOES A LONG WAY
Wipe up any spills immediately and clean the appliance
compartments at least twice a year.
FAQs
Why is the green LED Power On Light flashing?
This light will fl ash continuously when the appliance is fi rst
plugged in until the unit reaches the selected temperature.
What does the alarm or "buzzer sound" mean?
If the temperature inside the cabinet gets warmer, the High
Temp alert will sound. It's best to make sure your freezer is on a
level surface, and the door closes freely and with a proper seal.
Once you close the freezer door, leave it closed so the freezer
temperature can decrease. If this does not correct the issue,
check your User Manual for information on how to reset the
alarm.
a question?
owner support
frigidaire.com / 1 (800) 374-4432
frigidaire.ca / 1 (800) 265-8352
Upright 20 Cu Ft Freezer
Have Want
help?
Get started with your
QUICK START GUIDE
3
2
1
EASY-TO-CLEAN, SMOOTH EXTERIOR
Our smooth exterior fi nish wipes down more easily than
traditional textured fi nishes.
The freezer temperature is warmer than preferred. What's
wrong?
If the freezer temperature is warmer than you'd like, adjust
the control to a colder setting until the freezer temperature is
satisfactory. Allow 24 hours for the temperature to stabilize.
Why does my freezer seem to run continuously?
Your freezer is equipped with an energy-effi cient variable speed
compressor. It actually saves energy running more frequently.
Find more troubleshooting tips in the back of your User
Manual.
LET'S MAKE IT OFFICIAL!
Need
service?
5
3
6
Take the fi rst step to becoming a part of the
Frigidaire family by registering your upright
freezer.
Look for the PhotoregisterSM icon on your
registration card.
4
2