Publicité
respect the right polarity
as shown in figure 1.
-
Replace
the
rotating it towards the
position
.
-
Old batteries must be
removed and disposed
off in accordance with
current legislation as
they are harmful to the
environment.
WARNING: DO NOT DISPOSE OF BATTERIES IN FIRE. BATTERIES
MAY EXPLODE OR LEAK.
SAFETY FUNCTIONS
Safety device: the appliance is fitted with a safety
-
device that switches it off in the event of accidental
overheating (e.g. obstruction of air intake and outlet
grilles, motor turning slowly or not at all).
To reset, unplug the appliance from the outlet for a few
minutes, remove the cause of overheating, then plug in
again. If the appliance doesn't work please contact the
De'Longhi Customer Service.
Tip-over safety device: a tip-over safety device
-
turns the appliance off if it falls over or is positioned
inappropriately in such a way as to jeopardize safety.
The appliance emits a beep and a dot flashes on the
display. The appliance resumes operation a few seconds
after being placed in an upright position again.
TROUBLESHOOTING
In case "PF" is displayed and a warning sound is emitted,
there is a fault on the temperature sensor. If the problem
persists contact the Service Center.
If the appliance shuts off unexpectedly:
-
Check that the appliance is receiving power.
-
Check that the appliance is in the vertical position and
on a flat surface, as the safety tip-over switch may have
been tripped.
-
Check the temperature set and the timer: the appliance
may be off because the set temperature has been
reached or the time set on the timer has elapsed.
MAINTENANCE
-
Before carrying out any maintenance, always unplug
from the outlet.
-
During the season when the appliance is in use, clean
the air intake and outlet grilles regularly using a vacuum
cleaner.
cover
-
Never use abrasive powders or solvents to clean the
appliance.
-
The dust filter which retains impurities in the air, It is
integrated in the removable back cover. To clean the
filter, remove the grille by pulling outward. Blow it
lightly, then replace it into the appliance.
Fig. 1
NOTE: This equipment has been tested and found to
comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful
interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications. However, there is no guarantee that
interference will not occur in a particular installation. lf
this equipment does cause harmful interference to radio or
television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following
measures:
-
Reorient or relocate the receiving antenna.
-
Increase the separation between the equipment and
receiver.
-
Connect the equipment into an outlet on a
circuit different from that to which the receiver is
connected.
- Consult the dealer or an experienced radio/TV
technician for help. Modifications not approved by
the party responsible for compliance could void user's
authority to operate the equipment.
CAN ICES-3 (B) / NMB-3 (B)
14
Publicité
